Download This installation guide shows an instance of an installation on a Toyota Tundra; however, the installation might range on your vehicle, so it could be necessary to consult the Toyota service guide for specific directions in your 12 months model. Instruments Wanted: 10mm nut driver or socket, and Trim Removing Instruments (Optionally available) Be advised: These instructions could not embrace specifics for all vehicle configurations. 1. Set Parking brake and lower steering wheel to lowest setting. 2. On the Driver’s facet, remove the ground and side kick panels. 3. Using a 10mm software, remove the bolts from the decrease IPC (Instrument Panel Cluster) trim bezel. 4. Starting on the left hand side, gently separate the decrease IPC trim bezel, from the dash, and decrease it to the floorboard. 5. Please read all of the subordinate of this part earlier than proceeding a. Starting on the left hand side and working your manner around, gently separate the upper IPC trim bezel from the dash. Do not take away the bezel at this point. b. Whereas peering behind the higher IPC panel bezel, you will have to disconnect two connectors. Note: To stop breaking the connectors, DO NOT rock the connector back and forth. Squeeze the release and pull straight out.